Buffalo Bore .32 H&R Mag. 130 gr. Hard Cast +P

.32 H&R Mag. +P Buffalo Bore 130-grain Hard Cast

Looking for some power out of a smaller revolver? This load might surprise you.

By Richard Mann (RSS)
April 3, 2012

Consistent with its tradition of offering hard-cast revolver loads that drive deep, Buffalo Bore’s +P .32 H&R Mag. load does so with gusto. A 130-grain bullet at more than 1,000 fps from a 3-inch barrel is nothing to laugh at, and this bullet will open a modest wound cavity in a block of gelatin, even without expanding. It will also penetrate in excess of 31 inches. If you have a Ruger or Smith & Wesson revolver in .32 H&R Mag. and want a carry load that will penetrate any bad guy you encounter—through and through—this is the way to go.

Load Handgun MV (fps) PEN (inches) EXP (inches) RW (grains)
.32 H&R Mag. +P Buffalo Bore 130-grain Hard Cast Ruger SP101 (3-inch barrel) 1,024 31+ .312 130

Tags: , ,


Comments

Leave a Reply

Your email address will not be published. Required fields are marked *

*


You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>